LUBE电动泵,AMO-II-150S,AMO-III DS,AMO-IIIDSL,AMR-III DS,

LUBE润滑油泵 LUBE润滑油 LUBE润滑系统 LUBE润滑配件...

www.evkey.com

业务联系:杨玲玲手机:13358055735 （微信同手机号）

E-mail:evkey8@126.com

日本LUBE油气混合阀,日本进口LUBE油气混合型定量阀,加工中心油气混合阀,机床油气混合,油气分配器,分油器,分配器

LUBE润滑泵AMO-II -150S,AMO-III DS,AMO-IIIDSL,AMR-III DS,
LUBE油泵AMS-1,AMS-15,AMS-3,AMS-6
日本原装马扎克精密电动润滑油泵AMO-II-150S型
LUBE Automatic intermittent gear pump AMO-II -150S,AMO-III DS,AMO-IIIDSL,AMR-III DS

AMO-II -150S-1
AMO-II-150S-1-3
AMO-II-150S-1-P
AMO-II-150S-1-P-3
AMO-II-150S-2
AMO-II-150S-2-3
AMO-II-150S-2-P
AMO-II-150S-2-P-3
AMO-III DS-1
AMO-III DS-1-3
AMO-III DS-2
AMO-III DS-2-3

AMO-IIIDSL-1 100V 1.8L
AMO-IIIDSL-2 200V 1.8L
AMO-IIIDSL-2 100V 3.0L
AMO-IIIDSL-2 200V 3.0L
AMR-III DS-1
AMR-III DS-1-3
AMR-III DS-2
AMR-III DS-2-3
AMS-1-1
AMS-1-1L
AMS-1-2
AMS-1-2L

AMS-15-1
AMS-15-1L
AMS-15-2
AMS-15-2L
AMS-3-1
AMS-3-1L
AMS-3-2
AMS-3-2L
AMS-6-1
AMS-6-1L
AMS-6-2
AMS-6-2L

CODE NO.:202067
CODE NO.:202069
CODE NO.:202071
CODE NO.:202073
CODE NO.:202068
CODE NO.:202070
CODE NO.:202072
CODE NO.:202074
CODE NO.:285301
CODE NO.:285303
CODE NO.:285302
CODE NO.:285304

CODE NO.:285331
CODE NO.:285332
CODE NO.:285333
CODE NO.:285334
CODE NO.:112141
CODE NO.:112143
CODE NO.:112142
CODE NO.:112144
CODE NO.:102401
CODE NO.:102403
CODE NO.:102402
CODE NO.:102404

CODE NO.:102416
CODE NO.:102418
CODE NO.:102417
CODE NO.:102419
CODE NO.:102405
CODE NO.:102407
CODE NO.:102406
CODE NO.:102408
CODE NO.:102489
CODE NO.:112094
CODE NO.:102490
CODE NO.:112095

日本LUBE油气混合阀,日本进口LUBE油气混合型定量阀,加工中心油气混合阀,机床油气混合,油气分配器,分油器,分配器

不要卸下给油滤网，会导致异物混入。
吸滤器1年换1次或者清洗。
稀油因夏天，冬天油温不同导致粘度变化，所以请注意使用粘度范围内的稀油。
不要使用特殊添加物稀油、水溶性稀油、溶剂等。
定期检测使用中的稀油是否混入异物等，发现异物时请立即清洗油箱，更换新油。
请注意电压等错误。
吐出口的接头不要拧过头。

Do not remove the oil fill strainer in order to keep the pump clear of foreign matter.
Replace the suction filter at least once a year.
Oil viscosity varies with oil temperature. Be sure to use oil within the working viscosity range. Refer to us if you need.
Do not use any special additive-contained oil, water soluble oil, or solvent.
Periodically check the oil in the reservoir for impurities. Replace it, if necessary, with fresh oil immediately.
Be sure to clean the reservoir before replacing oil.
Make sure that proper voltage is applied.
Do not over tighten the discharge joint.
Low-oil viscosity versions are available. Contact us for information.

润滑系统、泵维修-更换-调试，Repair-Replace-Adjust
LUBE电动泵,AMO-II -150S,AMO-III DS,AMO-IIIDSL,AMR-III DS,AMS-1,AMS-15,AMS-3,AMS-6
LUBE Automatic intermittent gear pump,Motor driven continuous gear pump
AMO-II -150S,AMO-III DS,AMO-IIIDSL,AMR-III DS,AMS-1,AMS-15,AMS-3,AMS-6